Alienware M11x R2: A Legend Rebornby Jarred Walton on July 9, 2010 4:05 AM EST
Ultraportable Gaming Revisited
The original M11x was able to run all of our test games at anywhere from medium/mainstream (Crysis: Warhead and Dirt 2) to High and in some cases Very High details at the native 1366x768 resolution while maintaining at least 30FPS. What does the update bring in terms of gaming? Well, not a whole lot actually. A few games are faster, and some are slower as well (likely because of driver changes, though perhaps Optimus is a bottleneck at higher frame rates). In general, though, the overclocked SU7300 in the original M11x was very close to maxing out the GT 335M GPU, particularly at Medium/High detail settings. Let's start with our minimum settings performance comparison, though, and then we'll get into performance at higher quality settings on the next page.
Most of the games show performance improvements, though a few increases may come more from the drivers than the CPU upgrade. Likewise, we suspect the newer drivers may also be the reason some games drop slightly at low detail settings. Battlefield: Bad Company 2 shows the largest increase, going up a substantial 76%. DiRT 2 improves 20%, Batman by 8%, Far Cry 2 goes up 9%... and the rest of the gaming results actually decreased. The original M11x was 7% faster in Crysis: Warhead, 21% faster in Empire: Total War, 6% faster in Mass Effect 2, and 25% faster in STALKER: Call of Pripyat.
The other oddity is that while the i7-640UM should be quite a bit faster than the overclocked SU7300, there are five out of nine titles where the ASUS N61Jv beats the M11x R2—in other words, a faster CPU with a slower GPU comes out on top. Alienware specs state that the memory in the M11x runs at DDR3-800, which may be where some of the performance deficit is coming from, or again a difference in drivers may be coming into play.
It would be great if we could pinpoint whether the drops (and increases) are coming from the new 258.47 driver or something else, but since we don't have the original M11x or the N61Jv anymore we are left guessing. Part of the problem with the above charts is that all of these results are at minimum detail settings, which is obviously not the intended use of the M11x. Let's look at the M11x R2 with higher quality settings, and then we'll return to the question of whether the original is really faster at many games.
Post Your CommentPlease log in or sign up to comment.
View All Comments
blyndy - Friday, July 9, 2010 - linkWhy the F**K does Alienware, for all its awesome customisability, poke a stick in the eye with reflective displays!?
I would own a m17x if it wasn't for the shit screen. Give me the option for an RGB display but NOT for a matte finish? They can keep it.
plewis00 - Friday, July 9, 2010 - linkFor everyone who complains about glossy displays there is someone who prefers them. I am one of those people. And if the majority disliked glossy displays the industry as a whole wouldn't use them.
Matte displays attract dirt and fingerprints which are then harder to clean than glossy ones, that is a fact.
I don't know why everyone complains so much about them - true, in this instance the low contrast nature of the M11x display is bad but being glossy is a matter of taste, and given the choice, I would take the glossy display over the matte one, obviously you and others differ here, but whereas low-contrast is bad for all users, the display coating is definitely an opinion matter.
LaughingTarget - Friday, July 9, 2010 - linkSounds to me the problem can be resolved by, you know, not touching the screen.
plewis00 - Friday, July 9, 2010 - linkJust because I don't touch my screen doesn't mean other people in the vacinity don't...
Or if you are in a rush and grab the computer. Or if you sneeze on it. Any number of things can get dirt on the screen, but I'm sure you knew that and were just being facetious and annoying for no apparent reason...
quiksilvr - Friday, July 9, 2010 - linkFirst off, I don't know what matte screens you're talking about but glossy screens attract dust and fingerprints like no other.
If you are using the glossy screen for mainly home use and have it set up so there is no reflecting light, then I would say that glossy is the way to go.
LaughingTarget was merely pointing out the holes in your logic. For on-the-go use and for viewing the screen more easily, matte is the way to go.
Gloss is only there to compensate for the poor screen quality beneath that most manufacturers don't want to spend extra money on. I've seen matte displays with great contrast ratios AND given that the screen isn't a mirror, makes it usable in a well lit environments.
And as for the whole cleaning thing, they are the same. Just use the LCD cleaner with the cloth and both get just as clean.
plewis00 - Friday, July 9, 2010 - linkWell, I agree with most of what you say, however 'LaughingTarget' was being a tool. Whatever I do, some moron will come across to my computer screen or laptop in the day and point with the fleshy part of their finger having previously been stuffing their face with something greasy and unhealthy, so 'not touching' it just doesn't happen.
I'm sure matte displays have their place, but there are times when glossy screens have a price premium and people do pay that premium for them (not me personally). And I have a Dell 2005FPW attached to one of my computers which is (as far as I know) a S-IPS panel with a great contrast ratio and matte finish, far outpacing most of the TN panels built 3-4 years later I seem to come across.
Personally, I still prefer and will continue to use glossy screens where possible (one of which used to be the stunning RGBLED in the SXPS16). It doesn't matter what someone says, it is down to personal preference ultimately - I'm sure someone will spin me a load of rubbish about how I don't take graphics or image work seriously because I just said that but they would be wrong (and I hope that isn't you). What is universally agreed though is that high contrast and gamut is better.
And yes, I do own an M11x and my complaint is not with the glossy LCD layer but with the hideously poor contrast and terrible vertical viewing angle.
LaughingTarget - Friday, July 9, 2010 - linkUnderstand what tool means. Whom am I being a tool for, pray tell? Some secret international conglomerate of matte monitor manufacturers?
At the end of the day, your piss poor behavior using your expensive piece of hardware is hardly a great reason to buy a lesser monitor. If you can't pop open the screen without grubbing the monitor and hang around people with a total lack of consideration, that doesn't somehow make the glossy mess any better. You shouldn't be buying the m11 if you regularly bring the unit to places where folks smudge Cheeto dust all over it. That's what $300 Netbooks were invented for.
As for dust, close the thing when not in use. Problem solved.
plewis00 - Friday, July 9, 2010 - linkLook it up on Urbandictionary if you don't get it.
Yes, you are a tool for being undeniably facetious and smug with your response without adding anything to the conversation. You may not agree with my use of glossy screens as do others but slating it or making a pointless remark like 'don't touch it' doesn't add anything, just like your last comment.
And I wasn't talking about my M11x, I was talking about any LCD (matte or glossy), I mean at work people come to show you things and poke the screen - I work in an office where it's 90% women, they don't listen when I say 'don't touch the screen, it damages it' even if I do work in IT.
Dust appears on screens and keyboards even if you do close them after use, it's these annoying things called static electricity and gravity but being such a smartarse you must've already known that.
erple2 - Saturday, July 10, 2010 - linkHonestly, the initial response of LaughingTarget I thought was pretty reasonable, even funny.
Clearly, the solution <i>is</i> not to touch it. Whether you can fully control whether people other than yourself touch the screen is a side issue, but you can at least prevent your own fingerprints on the laptop.
Regardless, glossy vs. matte is, I suppose, as much about personal taste. I personally think that glossy is exceptionally annoying (and inferior from a practicality standpoint), but that's my opinion. I also think my opinion is based on facts. Whether those facts are important to you is a different story.
BTW, touching a screen is not a male/female thing. I work in an office where it's about 80% men, and they still touch screens, even after being told not to.
blyndy - Friday, July 9, 2010 - linkThe slight mirror layer over the whole display contents is what is unacceptable for me and others. They're obviously acceptable to some and that's fine, but for people who prioritise 'usable' over 'sleek' our options are negligible, hence the frustration.
"Matte displays attract dirt and fingerprints which are then harder to clean than glossy ones, that is a fact."
*turns off desktop lcd (matte)* ...I see a few smudges, but I have to shift my head from side to side to see them, and they're invisible when the screen is on, completely unobtrusive either way. I don't go poking the screen too much anyway, with that said it's simple to clean if ever I happen to rub my hands all over it. With a glossy screen though you HAVE to clean it if you don't want it to look dirty.
Anyway my main gripe is that for all of Alienware customisation options they don't include a matte screen, on machines that are supposed to be uncompromising and for hardcore users.
Especially when all they have to do is remove the clear plastic cover.