Ryzen 5000 Mobile: SoC Upgrades

While the introduction page focuses mainly on the change to Zen 3 cores, AMD has explained to AnandTech that there are plenty of other changes in this update which enable both performance and efficiency, as well as battery life enhancements, for users.

From this point on I will start using the silicon codenames, such as

  • Cezanne (Ryzen 5000 Mobile with Zen 3),
  • Lucienne (Ryzen 5000 Mobile with Zen 2),
  • Renoir (Ryzen 4000 Mobile, all Zen 2),
  • Vermeer (Ryzen 5000 Desktop, all Zen 3),
  • Matisse (Ryzen 3000 Desktop, all Zen 2)

Double Cache and Unified Cache for Cezanne

To reiterate the primary SoC change for Cezanne compared to Renoir, the eight cores now have a unified cache rather than two cache segments. On top of this, the cache size has also doubled.

This is similar to what we saw on the desktop, when AMD introduced Vermeer – Vermeer with Zen 3 had a unified cache over Matisse with Zen 2. At that time, AMD was pointing to the unified cache enabling better gaming performance as it lowered the ‘effective’ latency for CPU memory requests in that combined cache region. The same thing is expected to hold true for the new Cezanne silicon in Ryzen 5000 Mobile, and will play a key part in enabling that +19% IPC increase from generation to generation.

Improved Memory Controller for Cezanne and Lucienne

One of the key metrics in mobile processors is the ability to eliminate excess power overhead, especially when transitioning from an active state to an idle state. All major silicon vendors that build laptop processors work towards enabling super-low power states for when users are idle, because it increases battery life.

A lot of users will be used to features that keep the processor cores in low power states, or the graphics, but also part of this is the interconnect fabric and the memory controller. One of the new developments for Ryzen 5000, and in both Cezanne on Zen 3 and Lucienne on Zen 2, is that AMD has enabled deeper low-power states for the memory physical layer (PHY) interface. This enables the system to save power when the memory subsystem is either not needed or in a period of low activity. This means putting the fabric and memory on its own voltage plane, but also enabling the required logic to drive it to a lower power when idle. AMD states that the low-dropout regulators (LDOs) are configured to enable this transition, and in certain circumstances, allow the PHY to be bypassed to further lower power consumption.

The tradeoff with having a part of the processor in such a low power state is the time it takes to recover from idle, which is also a metric to keep track of. AMD is stating that the design in Ryzen 5000 also enables a fast exit to full activity, meaning that the high performance modes can be entered quickly.

Also on the memory front, it would appear that AMD is doubling capacity support for both LPDDR4X and DDR4. For this generation, Cezanne systems can be enabled with up to 32 GB of LPDDR4X-4267 (68.2 GB/s), or up to 64 GB of DDR4-3200 (51.2 GB/s). The benefits of LPDDR4X are lower power and higher bandwidth, while DDR4 enables higher capacity and a potentially upgradable design.

Per-Core Voltage Control for Cezanne and Lucienne

In line with the same theme of saving power, not only should the periphery of the core be managed for idle use, but the cores should as well. In Ryzen 4000 Mobile, AMD had a system whereby each core could have a separate frequency, which saved some power, but the drawback was that all the cores were on a single voltage plane and so even if a core was idle when another one was heavily loaded, all cores were running at that top voltage. This changes with all members of the Ryzen 5000 Mobile family, as both Cezanne and Lucienne will both feature voltage control on a per-core level.

The slide from AMD shows it best – the cores running at higher frequencies get higher voltage, and the cores that are idling can reduce their voltage to save power. One of the main limits to enabling this sort of profile, aside from actually having the control to do it in the first place, is to do it fast enough for it both to count towards power consumption but also such that it is transparent to the user – the cores should still be able to come to a high voltage/high frequency state within a suitable time. AMD’s design works with operating system triggers and quality of service hooks to apply high-frequency modes in a task-based format.

On AMD’s desktop processors, we saw that the introduction of a feature called CPPC2 helped enable this, and the same is true on the mobile processors, however it took another generation to do the required design and firmware changes.

Power and Response Optimization (CPPC2) for Cezanne and Lucienne

As we accelerate into the future of computing, making the most out of each individual bit of silicon is going to matter more. This means more control, more optimization, and more specialization. For Cezanne and Lucienne, AMD is implementing several CPPC2 features first exhibited on desktop silicon to try and get the most out of the silicon design.

‘Preferred Core’ is a term used mostly on the desktop space to indicate which CPU core in the design can turbo to the highest frequency at the best power, and through a series of operating system hooks, the system will selectively run all single-threaded workloads on that core assuming no other workload is present. Previously, threads could bounce around to enable a more equal thermal distribution – AMD will now selectively keep the workload on the single core until thermal limits kick in, enabling peak performance and no extra delays from thread switching. For overclockable systems, this typically also represents the best core for boosting the frequency, which becomes relevant for Ryzen 5000 Mobile and the new HX series processors.

Another part of CPPC2 is frequency selection, which reduces the time for the transition from low-frequency to high-frequency from 30 milliseconds down to under 2 milliseconds. This equates to a 2-frame adjustment in frequency being reduced down to sub-frame adjustments. The consequences of this enables workloads that occur for shorter than 30 milliseconds can take advantage of a momentarily higher frequency and get completed quicker – it also enables the system to be more responsive to the user, not only in idle-to-immediate environments, but also in situations where power is being distributed across the SoC and those ratios are adjusting for the best performance, such as when the user is gaming. Also enabling load-to-idle transitions on the order of 2 milliseconds improves battery life by putting the processor in a lower power state both quicker and more often, such as between key presses on the keyboard.

The third part of CPPC2 is the migration away from discrete legacy power states within the operating system. With an OS that has a suitable driver (modern Windows 10 and Linux), frequency control of the processor is returned back from the OS to the processor, allowing for finer grained transitions of when performance or power saving is needed. This means that rather than deal with the several power states we used to, the processor has the full continuous spectrum of frequencies and voltages to enable, and will analyze the workflow to decide how that power is distributed (the operating system can give hints to the processor to aid in those algorithms).

GPU Improvements on Cezanne and Lucienne: Vega 8 to Vega 8+

As mentioned on the previous page, one of the criticisms leveled at this new generation of processors is that we again get Vega 8 integrated graphics, rather than something RDNA based. The main reason for this is AMD’s re-use of design in order to enable a faster time-to-market with Zen 3. The previous generation Renoir design with Zen 2 and Vega 8 was built in conjunction with Cezanne to the point that the first samples of Cezanne were back from the fab only two months after Renoir was launched.

If we look at the change in integrated graphics from the start of Ryzen Mobile. The first generation Raven Ridge was built on 14nm, had Vega11 graphics, and had a maximum frequency around 1200 MHz. The graphics in that Renoir design were built on 7nm, and despite the jump down from Vega11 to Vega8, efficiency was greatly increased and frequency had a heathy already a jump up to 1750 MHz. Another generation on to Cezanne and Lucienne, and the graphics gets another efficiency boost, enabling +350 MHz for added performance.

Part of this update is down to tweaks and minor process updates. AMD is able to control the voltage regulation better to allow for new minimums, reducing power, and has enabled a new frequency sensitive prediction model for performance. With the greater power controls on the CPU and SoC side, this means that power budget can be more readily accessible by the integrated graphics, allowing for higher peak power consumption, which also helps boost frequency.

Note that these features apply to both Cezanne and Lucienne, meaning that the Zen 2 products in the Ryzen 5000 Mobile do get a sizeable boost in graphics performance over Renoir here. Ultimately it is that 15 W market for which this update is aimed, given that the H-series (including HS and HX) are likely to be paired with discrete graphics cards.

As and when AMD decides to move from Vega to RDNA, we’re likely going to see some of the Cezanne be re-used such that we might see Zen3 + RDNA in the future, or the combined Zen 4 + GPU chip might be a full upgrade across the board. This is all speculation, but AMD’s CEO Lisa Su has stated that being able to re-use silicon designs like this is a key part of the company’s mobile processor philosophy going forward.

Security Updates in Cezanne

One of the features of Zen 3 is that it enables AMD’s latest generation of security updates. The big update in Zen 3 was the additional of Control Flow Enforcement Technology, known as CET. This is where the processor will create shadow stacks for return calls to ensure that the correct return addresses are called at the end of functions; similarly indirect branch jumps and calls are monitored and protected against should an attacker attempt to modify where an indirect branch is headed.

Both AMD and Intel have spoken about including Microsoft Pluton security in their processors, and we can confirm that neither Cezanne nor Lucienne have Pluton as part of the design. Both AMD and Intel have stated that it will be integrated ‘in the future’, which seems to suggest we may still be another generation or two away.

Process Node Updates on Cezanne and Lucienne

Perhaps one of the smaller updates this time around, but AMD has stated that both Cezanne and Lucienne use the latest intra-process node updates on N7 for these products. While both previous generation Renoir and these two use TSMC’s N7 process, over the lifecycle of the manufacturing node minor changes are made, sometimes to reduce defect density/increase yield, while others might be voltage/frequency updates enabling better efficiency or a skew towards better binning at a different frequency. Usually these additions are minor to the point of not being that noticeable, and AMD hasn’t said much beyond ‘latest enhancements’.

AMD Ryzen 9 5980HS Cezanne Review CPU Tests: Core-to-Core and Cache Latency
POST A COMMENT

218 Comments

View All Comments

  • Stuka87 - Wednesday, January 27, 2021 - link

    Really no reason for them to move away from Vega for these chips. Do you also complain that Intel has not changed their IGP for years?

    The efficiency of Vega is quite good when not OC'ed way past where it should be like in the desktop cards. And it still offers adequate performance for the majority of people looking at a laptop. For anything more you want a discrete card anyway.
    Reply
  • Unashamed_unoriginal_username_x86 - Thursday, January 28, 2021 - link

    Just on the Intel point, it's worth noting that they've had to develop GPU IP specifically for their CPUs. The paradigm has changed with the advent of Xe scalable, but even then the first product released with Xe was a CPU. Obviously AMD is disadvantaged with RTG not being as tightly nit as Intel's GPU group Reply
  • IGTrading - Tuesday, January 26, 2021 - link

    Amazing execution from AMD.

    Unfortunately, the only way they could gain some significant market share would be if they manage to source enough capacity from TSMC.

    The demand for AMD CPUs in the market is huge.

    At Amazon, AMD's chips come with a +50% price premium on a regular basis. SONY & Microsoft are going nuts trying to get more chips from AMD.

    If AMD managed to negotiate well their cut from TSMC, we should see an explosion of AMD's revenue in 2021.

    The new crypto boom will only propel AMD's ASPs even higher, although it will annoy the IT enthusiasts.

    Great piece, Ian! Thanks.
    Reply
  • Deicidium369 - Wednesday, January 27, 2021 - link

    Not a question of capacity - it's the fact that TSMCs fragile long supply chain is broken and limited resources have to be allocated - and AMD is contractually obligated to reach delivery targets for the Console SOCs. They have to use the limited resources to provide the ultra high volume, ultra low margin SOCs over their high margin PC GPUs and CPUs.

    In this case, it's not AMD's fault - it's an issue with TSMC
    Reply
  • Spunjji - Thursday, January 28, 2021 - link

    "TSMCs fragile long supply chain is broken"
    ---citation needed---
    Reply
  • Qasar - Thursday, January 28, 2021 - link

    ---will never see it--- Reply
  • e36Jeff - Tuesday, January 26, 2021 - link

    Minor quibble, the chart at the bottom of the first page lists the Flow X13's memory speed as LPDDR4-3267 rather than 4267. Reply
  • Silma - Tuesday, January 26, 2021 - link

    It's one thing to develop great processors, it's entirely another thing to effectively ship them.
    I would have liked to purchase a Zen 3 processors for my new PC, but I had to make do with a 3700X.
    Would have been interested by an RTX 3070 or an AMD latest gen graphic card, but again, they only seem to exist in the hands of testers, YouTubers and twitchers.

    Let's see if AMD can really ship a decent number of Zen 3 mobile CPUs.
    Reply
  • bji - Tuesday, January 26, 2021 - link

    All your problems are easily solved. Just go to MicroCenter! Reply
  • Qasar - Tuesday, January 26, 2021 - link

    and if there is no microcenter near you, then what ? Reply

Log in

Don't have an account? Sign up now